Installing the Terminal
•
Plug the power supply into the side of the terminal near the
number 1 button.
•
Turn the terminal on by pressing the power button labelled 6
on the diagram to the right.
•
If prompted, enter the Merchant ID (MID)
.';
•
Enter your Wi-Fi password
•
The terminal will now connect to your Wi-Fi
•
Mobile
•
Your terminal will search for a network connection
and connect automatically
•
The terminal will now complete a short installation
and will be ready for use.
Note:
Your
Merchant ID
and
Manager Passcode
will be sent
to you via email.
It is important that you change your Manager Passcode to a
memorable number and keep it safe.
To change the Manager Passcode:
•
From the idle screen, press the red key to enter the
System Menu
•
Enter the Manager Passcode provided to you and
press OK.
•
Scroll down using the # Key to
'Change passcode'
and
press OK.
•
Erase the existing
passcode
using the yellow Key.
•
Now enter your chosen
New passcode.
•
NOTE: Please keep your New passcode SAFE.
Contactless Transactions
• From the idle screen, key in the transaction amount and
press OK (green key).
•
The terminal will display the contactless symbol
•
Ask the customer to present their contactless card or
device to the terminal screen. The Terminal will BEEP
when it has read the card or device.
• The card terminal will then request an Authorisation and
complete the transaction.
Chip and Pin Transactions
• From the idle screen, Key in the transaction
amount and press OK (green key).
•
Ask the customer to insert their card into the
terminal.
• When prompted by the terminal the customer
should enter their PIN and press OK.
• The device will then go online to authorise (or
decline) the transaction.
• The customer should not remove their card until
prompted to do so.
• The card terminal will then request an
Authorisation and complete the transaction.
To Next Page
Need help?
General
