Product Identification
Information
i03663726
Plate Locations and Film
Locations
SMCS Code: 1000
Engine Identification
Caterpillar engines are identified with serial numbers,
with performance specification numbers, and with
arrangement numbers. In some of the cases,
modification numbers are used. These numbers are
shown on the Serial Number Plate and the
Information Plate that are mounted on the engine.
Caterpillar dealers need these numbers in order to
determine the components that were included with
the engine. This permits accurate identification of
replacement part numbers.
Serial Number Plate
Illustration 23 g00123229
Typical serial number plate
The Serial Number Plate is located on the left side of
the cylinder block near the rear of the engine.
The following information is stamped on the Serial
Number Plate: engine serial number, model and
arrangement number.
Information Plate
Illustration 24 g00755014
The Information Plate is on the valve cover. The
following information is stamped on the Information
Plate: engine's maximum altitude, horsepower, high
idle, full load rpm, fuel settings and other information.
European Union
Illustration 25 g01880193
This plate is positioned on the bottom left side of the
plate for the PIN.
Note: The CE plate is on machines that are certified
to the European Union requirements that were
effective at that time.
For machines compliant to 2006/42/EC, the following
information is stamped onto the CE plate. For quick
reference, record this information in the spaces that
are provided below.
• Engine Power Primary Engine (kW)
SEBU7125-13
21
Product Information Section
Product Identification Information
To Next Page
Loading...