Cateye Enduro CC-ED400

To Next Page

ENDURO ENG 1

Before using the computer, please thoroughly read this

manual and keep it for future reference.

Warning / Caution

• Donotconcentrateonthecomputerwhileriding.Ridesafely!

• Installthemagnet,sensor,andbracketsecurely.Checktheseperiodi-

cally.

• Ifachildswallowsabattery,consultadoctorimmediately.

• Donotleavethecomputerindirectsunlightforalongperiodoftime.

• Donotdisassemblethecomputer.

• Donotdropthecomputertoavoidmalfunctionordamage.

• Whencleaningthecomputer,bracketandsensor,donotusethinners,

benzene,oralcohol.

• Riskofexplosionifbatteryisreplacedbyanincorrecttype.

Disposeofusedbatteriesaccordingtolocalregulations.

• LCDscreenmaybedistortedwhenviewedthroughpolarizedsunglass

lenses.

CATEYE

ENDURO

CYCLOCOMPUTER

CC-ED400

Maintenance

• Tocleanthecomputeroraccessories,usedilutedneutraldetergent

onasoftcloth,andwipeitoffwithadrycloth.

• Ifthegapsbetweenthebuttonsandtheunitgetcloggedwithmudor

sand,washthemawaywithwater.

Replacing the battery

Whenthedisplaybecomesdim,replacethe

battery.Installanewlithiumbattery(CR2032)

withthe(+)sidefacingupward.

*Afterreplacingthebattery,besuretosetthe

unitagainaccordingtotheprocedurespeci-

edin“Preparingthecomputer”(page3).

Troubleshooting

No display.

Isbatteryinthecomputerrundown?

Replacewithnewbatteriesaccordingtotheprocedurespecied

inthesection“Replacingthebattery”.

Incorrect data appear.

Followtheproceduredescribed“Preparingthecomputer”(page3).

Current speed does not appear.(First,short-circuitthecontactofthe

computerafewtimeswithapieceofmetal.Ifcurrentspeedappears,

thecomputerisworkingneandthecauseshouldbeattributedtothe

bracketorthesensor.)

Isthewirebroken?

Eveniftheoutsideofthewirelooksnormal,therecouldbe

damage.Replacethebracketsensorkitwithanewone.

Istheclearancebetweenthesensorandthemagnettoolarge?

Arethemagnet’scenterandthesensor’smarkinglinealigned?

Re-adjustthepositionsofthemagnetandthesensor.

(Theclearanceshouldbelessthan5mm.)

Isthereanythingstickingonthecontactofthecomputerorthe

bracket?

Cleanthecontactwithacloth.

COIN

CR2032

Open

Speciﬁcation

Battery/Batterylife

Lithiumbattery(CR2032)x1/Approx.3year

*Thefactory-loadedbatterylifemightbeshorterthantheabove-mentionedspecication.

Controller 4bit,1-chipmicrocomputer(Crystalcontrolledoscillator)

Display Liquidcrystaldisplay

Sensor Nocontactmagneticsensor

Tiresizetobe

selected

26”,700c,27”,16”,18”,20”,22”and24”,ortirecircumferenceof

100cm-299cm(initialvalue:26inch)

Working

temperature

32°F-104°F(0°C-40°C)(Thisproductwillnotdisplayappropri-

atelywhenexceedingtheWorkingTemperaturerange.Slowresponse

orblackLCDatlowerorhighertemperaturemayhappenrespectively.)

Dimensions/weight

2-3/16”x1-15/32”x5/32”(55.5x37.5x18.5mm)/1.06oz(30g)

*Thespecicationsanddesignaresubjecttochangewithoutnotice.

Limited warranty

2-Year: Computer only

(Accessories/Bracket sensor and Battery Consumption excluded)

CatEyecyclecomputersarewarrantedtobefreeofdefectsfrommaterialsandworkmanship

foraperiodoftwoyearsfromoriginalpurchase.Iftheproductfailstoworkduringnormal

use,CatEyewillrepairorreplacethedefectatnocharge.ServicemustbeperformedbyCat-

Eyeoranauthorizedretailer.Toreturntheproduct,packitcarefullyandenclosethewarranty

certicate(proofofpurchase)withinstructionforrepair.Pleasewriteortypeyournameand

addressclearlyonthewarrantycerticate.Insurance,handlingandtransportationchargesto

CatEyeshallbebornebypersondesiringservice.ForUKandREPUBLICOFIRELANDcon-

sumers,pleasereturntotheplaceofpurchase.Thisdoesnotaffectyourstatutoryrights.

PleaseregisteryourCatEyeproductonthewebsite.

http://www.cateye.com/en/support/regist/

2-8-25,Kuwazu,HigashiSumiyoshi-ku,Osaka546-0041Japan

Attn:CATEYECustomerServiceSection

Phone :(06)6719-6863 Fax :(06)6719-6033

E-mail :support@cateye.co.jp URL :http://www.cateye.com

[For US Customers]

CATEYE AMERICA, INC.

2825WildernessPlaceSuite1200,BoulderCO80301-5494USA

Phone :303.443.4595 TollFree :800.5CATEYE

Fax :303.473.0006 E-mail :service@cateye.com

Partskit

Bracketsensorkit

Wheel

magnet

Lithium

battery

Spare accessories

Standard accessories

1603391

1603491

1665150

CR2032

1699691N

Optional accessories

Heavydutybracket

sensorkit

In use

1603490

Need help?

Do you have a question about the Cateye Enduro CC-ED400 and is the answer not in the manual?

Summary

Maintenance and Troubleshooting

Replacing the Battery

Procedure to replace a dim display battery with a new lithium battery (CR2032), ensuring correct polarity.

Troubleshooting No Display

Check if the battery is run down and replace if necessary according to the 'Replacing the battery' section.

Troubleshooting Incorrect Data

Follow the procedure described in 'Preparing the computer' (page 3) for incorrect data issues.

Troubleshooting Current Speed

Check for short-circuit, wire breaks, sensor/magnet alignment, and contact cleanliness for speed issues.

Product Specifications and Warranty

Product Specifications

Details on battery, display, sensor, tire size, working temperature, and dimensions/weight.

Limited Warranty Information

Two-year limited warranty for computer defects, excluding accessories and battery.

Spare and Optional Accessories

Information on available spare and optional accessories for the cyclocomputer.

Installation Guide

Attaching the Bracket

Instructions for attaching the FlexTight™ bracket to the stem or handlebar using nylon ties.

Installing Sensor and Magnet

Steps for installing the magnet on the spoke and the sensor, ensuring correct zone and clearance.

Routing the Wire

Guide for securing the wire along the bicycle frame using nylon ties and spiral tube.

Removing and Installing Computer

How to remove and install the computer unit from the bracket by hand.

Computer Preparation and Settings

Initial Data Clearing

Procedure to clear all data by pressing the AC button on the back of the computer.

Setting Speed Unit

Instructions to select the speed unit between km/h and mph.

Setting Tire Size

Guidance on setting the tire size using simple or detailed methods, including a reference table.

Setting the Clock

Steps to set the clock display format (12h/24h) and time (hour/minute).

Operation Test

Check computer display of speed by turning the front wheel after installation.

Using the Computer Features

Measuring Screen Overview

Explanation of the measuring screen elements like speed, pace arrow, and speed unit.

Switching Computer Functions

How to cycle through different measurement data like Elapsed Time, Trip Distance, and Average Speed.

Starting and Stopping Measurement

Automatic measurement start/stop based on bicycle motion; flashing speed unit indicates measurement.

Resetting Measurement Data

Procedure to reset measurement data to zero by pressing and holding the MODE button.

Power-Saving Function

Automatic activation of power-saving screen after 10 minutes of no signal, displaying only the clock.

Calorie Consumption Calculation

How the computer measures calorie consumption based on speed and provides kcal per hour values.

Carbon Offset Calculation

Explanation of how carbon offset is calculated using trip distance and a conversion factor.

Changing Tire Size Setting

Instructions to change tire size by displaying ODO and pressing the SET button.

Setting the Clock

Method to enter clock setting mode by pressing the SET button on the back of the computer.