Cateye Volt400 Duplex

To Next Page

HL-EL462RC-H

Before using the light, read this

manual thoroughly and keep it for

future reference.

Manual

WARNING!!!

• Be sure to direct the light beam downward so

the driver approaching does not get dazzled.

• Before your trip, please make sure the light is

ﬁrmly mounted to the bracket and it lights up.

• Always attention to the remaining battery

power by checking the indicator periodically

while using.

CAUTION!

• Do not place it within children’s reach.

• In preparation for unexpected battery shutoff,

we recommend you carry a spare cartridge

battery and light.

• This product is water-resistant under normal

daily use and can be used in the rain. Howev-

er, do not intentionally submerge it in water.

• If the light unit or parts become dirty with

mud, etc., clean with a soft cloth which is

moistened with mild soap. Never apply paint

thinner, benzine or alcohol; damage will

result.

LITHIUM-ION BATTERIES

Cautions on recharging

• Avoid charging in direct sunlight or in a

vehicle parked under direct sunlight, and

make sure to charge only when the ambient

temperature is between 41°F and 104 °F

(5 and 40°C).

• Before charging, be sure that no dust or

other foreign objects attach to the USB

plug.

• Do not subject the light to vibrations while

charging.

• Once charging is complete, be sure to

disconnect the USB plug.

Cautions in use

• Charging, discharging, and storing in high

temperatures will cause the rechargeable

battery to deteriorate faster. Do not place

the light inside a vehicle or near a heater.

• When the operating time decreases signiﬁ-

cantly, the battery life is close to an end.

Replace the cartridge battery with a new one.

Cautions on storage

• Cool and dry storage is recommended.

For long period storage, it is important

to charge the battery 30 minutes every 6

months.

• When you store the cartridge battery alone,

be sure to install the cap. Otherwise, dam

age or a ﬁre may be caused by short circuit.

Cautions for dispose

Dispose of used cartridge batteries appropri-

ately according to local regulations.

Before Initial Use

This unit is shipped

with a small charge

to check the light. Be

sure to charge it before

use, according to the

instructions “HOW TO

CHARGE”.

1. Connect the light unit to your PC or a com-

mercial USB battery charger using the USB

cable. (Fig 1

–

The switch indicator turns on and charging

starts.

Indicator light:

Illuminated in red

Charging

Indicator light: Off

Charging is completed

* When your PC is in sleep state, the unit can-

not be charged.

* We recommend using 500+mAH (USB2.0)

USB battery charger.

* If using the Fast charging cradle2 (optional),

the indicator on the cradle turns on.

2. After charging is completed, remove the USB

cable, and install the charge jack cover.

* Charging and lighting times are approximate

values, and will vary by environmental and

user conditions.

* The optional cradle2 not only lets you charge

the battery by itself, but also gives you the

option of using it as a mobile battery.

Standard charging time

Approx.

(

USB 2.0

)

Securely fasten the helmet mount to the front

part of the helmet, wrapping the bracket strap

through the air vents on the helmet. (Fig 2

)

The bracket strap can be attached

either vertically or horizontally.

2. Mount the light unit onto the helmet mount.

(

)

3. Wear the helmet and adjust the angle of the

beam. (

)

4. To remove the light unit, pull out it forward

while pressing down on the release button

(

CAUTION!:

Check the screw on the bracket periodically,

and use it without any loosing. (

)

2 HOW TO MOUNT TO A HELMET

1 HOW TO CHARGE

OUT

EL462RCH-171211 2

Taillight integrated

cartridge battery

(BA-2.6-R)

Helmet mountUSB cable

(MICRO USB)

Light unit

ENG

Fast charging cradle 2

IN OUT

USB cable

Charge jack cover

To PC or USB

battery charger

Charging on the cradle

Optional

Cartridge battery

MICRO USB USB

Bracket strap

Light unit

Remove

Release button

Need help?

Do you have a question about the Cateye Volt400 Duplex and is the answer not in the manual?

The CatEye VOLT400 DUPLEX™ HL-EL462RC-H is a versatile, high-intensity LED light unit designed for helmet mounting, offering both front and rear lighting capabilities. This device is powered by a rechargeable lithium-ion cartridge battery and features a robust, water-resistant design suitable for various cycling conditions.

Function Description:

The VOLT400 DUPLEX™ serves as a dual-purpose light, integrating a front light and a taillight into a single compact unit. It is primarily designed for helmet mounting, providing illumination and visibility for cyclists. The front light offers multiple lighting modes, including High, Middle, Low, HyperConstant, and Flashing, catering to different visibility and battery life requirements. The taillight provides Constant and Flashing modes for rear visibility. A unique feature allows for simultaneous operation of both front and rear lights, with specific modes like High/Constant and Flashing/Constant. The device incorporates a mode memory function, which means it will turn on in the last lighting mode used.

The unit is rechargeable via a Micro USB plug, allowing connection to a PC or a commercial USB battery charger. An indicator light signals the charging status, turning red during charging and off when charging is complete. For enhanced charging convenience, an optional Fast charging cradle 2 is available, which not only charges the battery but can also function as a mobile battery.

Important Technical Specifications:

Light Source: High-intensity LED x 1
Cartridge Battery: BA-2.6-R (Li-ion 3.6V 2600mAH) is the standard battery. Optional cartridge batteries include Li-ion 3.6V 3400mAH (BA-3.4) and Li-ion 3.6V 2200mAH (BA-2.2).
Charge: Micro USB plug
Standard Charging Time: Approximately 6 hours (using USB 2.0)
Operating Temperature Range: Charging: 41°F - 104°F (5°C - 40°C); Operating: 14°F - 104°F (-10°C - 40°C)
Average Runtime at 20°C (Front Light Only):
- High: Approx. 3 hours
- Middle: Approx. 10 hours
- Low: Approx. 18 hours
- HyperConstant: Approx. 9 hours
- Flashing: Approx. 150 hours
Average Runtime at 20°C (Rear Light Only):
- Constant: Approx. 25 hours
- Flashing: Approx. 250 hours
Average Runtime at 20°C (Front/Rear Simultaneous):
- High / Constant: Approx. 3 hours
- Flashing / Constant: Approx. 30 hours
Recharge/Discharge Cycles: Approximately 300 times (until rated capacity drops to 70%)
Dimensions/Weight: 4-63/64" x 1-43/64" x 1-15/64" (127 x 42.5 x 31 mm) / 3.83 oz (108.5 g) (including cartridge battery)
Water Resistance: Designed for normal daily use and rain, but not for intentional submersion.

Usage Features:

Helmet Mounting: The device comes with a helmet mount that securely fastens to the front part of a helmet by wrapping a bracket strap through the air vents. The bracket strap can be attached either vertically or horizontally. The light unit then mounts onto this bracket.
Switch Operation: A single switch on the light unit (and an additional switch on the cartridge battery for rear light control) allows for turning the light on/off and cycling through the various lighting modes. Pressing and holding the switch typically changes between main modes (e.g., High, Middle, Low), while a double-click might activate specific modes like HyperConstant. A single click often cycles through modes within a group or activates flashing.
Battery Indicator: The switch itself acts as an indicator for remaining battery capacity. When it lights up, it signals low battery power, prompting the user to recharge soon.
Beam Adjustment: Once mounted, the angle of the beam can be adjusted to ensure optimal visibility and to prevent dazzling oncoming drivers.
Cartridge Battery System: The VOLT400 DUPLEX™ utilizes a replaceable cartridge battery system. The battery can be easily removed by turning it counterclockwise and installed by screwing it into the light unit until it clicks. This allows for quick battery swaps, extending usage time.
Optional Cradle: The optional Fast charging cradle 2 provides an alternative charging method and can also serve as a portable power bank, offering flexibility for charging other USB-powered devices.

Maintenance Features:

Cleaning: For dirt or mud, the light unit and its parts should be cleaned with a soft cloth moistened with mild soap. Harsh chemicals like paint thinner, benzine, or alcohol should be avoided to prevent damage.
Battery Care (Recharging):
- Charge only when ambient temperatures are between 41°F and 104°F (5°C and 40°C).
- Avoid charging in direct sunlight or inside a parked vehicle under direct sunlight.
- Ensure no dust or foreign objects are attached to the USB plug before charging.
- Avoid subjecting the light to vibrations during charging.
- Disconnect the USB plug once charging is complete.
Battery Care (Usage):
- High temperatures during charging, discharging, or storage can accelerate battery deterioration. Avoid placing the light inside a vehicle or near a heater.
- Replace the cartridge battery when operating time significantly decreases, indicating the end of its life.
Battery Care (Storage):
- Store in a cool and dry place.
- For long-term storage, charge the battery for 30 minutes every 6 months.
- When storing the cartridge battery alone, ensure the cap is installed to prevent damage or fire from short circuits.
Disposal: Used cartridge batteries should be disposed of appropriately according to local regulations.
Bracket Maintenance: Periodically check the screw on the bracket to ensure it is not loose, maintaining secure mounting.
Warranty: The light unit comes with a 2-year warranty covering defects in materials and workmanship. Deterioration of the cartridge battery is not covered under this warranty, as battery life is subject to usage and environmental factors.