Pg 8
Copies of the standards listed may be obtained from:
* National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
**
CSA International
8501 East Pleasant Valley Road
Cleveland, Ohio 44131-5575
To contact a qualified electrical installer.
To assure that the electrical installation is adequate and in conformance with National
Electrical Code, ANSI/NFPA 70 — latest edition*, or CSA Standards C22. 1-94, Canadian
Electrical Code, Part 1 and C22. 2 No. 0-M91 - latest edition** and all local codes and
ordinances.
Provide a circuit protected power service; preferably a Ground Fault Circuit Interrupter
("G.F.C.I."): 120-volt, 60 Hz, AC, with at least 5-amps of available service.
Enlist a qualified electrician to ensure the range hood and electrical lines are adequately
grounded and properly protected. NEVER electrically ground to a gas pipe.
Wire sizes (copper wire only) and connections must conform with the rating of the appliance
as specified on the model/serial rating label. Wire sizes must conform to the requirements of
the National Electrical Code ANSI/NFPA 70 — latest edition*, or CSA Standards C22. 1-94,
Canadian Electrical Code Part 1 and C22. 2 No. 0-M91 - latest edition** and all local codes and
ordinances. A U.L. - or C.S.A. - listed conduit connector must be provided at each end of the
power supply cable (at the range hood and at the junction box).
IMPORTANT: Observe all governing ordinances and local codes.
(Please consult with a qualified electrician for any electrical wiring)
It is the customer’s responsibility:
•
•
•
•
IMPORTANT: Save this Installation Guide for future reference and/or electrical inspector use.
The range hood should be connected with a circuit breaker protected power service.
Electrical Requirements
To Next Page
Loading...
