Cavius 2107-001 - Understanding Test Responses; Test Completion and Troubleshooting

17
When the test signal is sent out, the alarms will respond in two ways:
1. A single beep every 8 seconds indicates that the alarms are connected
and functioning.
2. Three short beeps every 8 seconds indicates a smoke sensor fault.
The alarm should be cleaned by running the vacuum (on a low setting)
around the smoke alarm chamber and tested again.
Oncethealarmshaveindicatedtheyareinterconnected;thebeepscanbe
stopped on each alarm with a short press of the test button.
TIP:Itissafetocoverthesoundoutputholewithyourngerduringthe
testing to minimise the sound level emitted.
Ifanyproblemsoccurduringtesting,visitwww.cavius.co.nzor
www.cavius.com.au for further trouble shooting.