250 Rebagger Auger Packer 2014
4 OF 10
WARNINGS
NEVER operate bagger with safety grate removed. This could lead to injury by getting caught in auger.
OSHA regulations pertaining to the electrical when maintenance is performed must be followed.
DO NOT OPERATE MACHINE WITH GUARDS REMOVED.
The purpose of this section is to alert operating and maintenance personnel to the possible dangers of this
type of equipment. Serious injury and/or equipment damage could result from not heeding these safety
precautions.
BEFORE OPERATING EQUIPMENT:
1) Any personnel working directly with or on this equipment should read this manual before
proceeding with equipment use.
2) Electricians should familiarize themselves with the electrical drawings before initial start-up
of equipment.
3) Other appropriate operating and maintenance personnel should familiarize themselves
with mechanical layout and general arrangement drawings before start-up of equipment.
4) Determine location of all emergency switches.
5) Be sure all guards are in place and observe all warning signs.
6) Check oil level in all motors.
7) Be sure electrical equipment is free of any accumulation of water.
8) Be sure all personnel are clear of operating mechanisms before connecting air.
9) Never start equipment without first checking for loose objects, tools and trash. All persons
in the immediate area of the equipment should be alerted prior to starting.
WHEN OPERATING EQUIPMENT:
1) Observe extreme caution when switches are turned on. Operation may begin
automatically after a time delay.
2) Do not open junction boxes or control panels unless you are a qualified electrician. Be
sure power is off. Except when electricians are performing maintenance, electrical
enclosures and junction boxes should always be securely closed.
3) Stop machine and disconnect power supply before servicing or repairing. Maintenance
and adjustments must be performed with all power supply disconnected unless otherwise
specified in this manual.
4) Do not attempt to defeat any safety switches. Serious injury could result.
5) While machine control power is on, do not activate limit switches manually. Serious injury
and/or machine damage could result. Disable machine before attempting any
maintenance or manual testing of components.
To Next Page
Loading...
Need help?
General
