What to do if thermostats trip in CBM SST 2200B?
If the thermostats trip due to overheating in your CBM Laboratory Equipment, leave the door open and wait a few minutes for the temperature to drop. Then, remove the cap (if there is one) and press the thermostat's reset button located at the back of the sterilizer.
How to fix CBM SST 2200B when it's plugged in but everything is off?
If your CBM Laboratory Equipment is plugged in, the green power switch is in the 'I' position, but everything is off (including the green light), the issue could be due to: * No power supply: Check the power supply. * Burned fuses: Replace the fuses in the fuse box within the mains socket. Remember to remove the power cable from the socket before replacing the fuses.
Essential safety precautions for operating the sterilizer.
Procedures for installing the sterilizer safely and ensuring proper airflow.
Steps for filling the water tank and connecting the power.
Requirements for demineralized water and waste water management.
Details on temperature, time, and drying for different cycles.
Steps to resolve issues related to power supply and fuses.
How to reset the overheat protection thermostats.
Common alarms related to temperature and pressure deviations.
Troubleshooting alarms associated with air leakage and door operation.
Resolution for alarms related to cycle timing and phase parameters.
General| Brand | CBM |
|---|---|
| Model | SST 2200B |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
