14
9
10
Draining the Beverage Brewing System
Troubleshooting
3
5
4
Press the top 3 buttons while pressing the
power ON/OFF button to the ON position.
The unit will perform a drainage cycle.
Unplug the beverage system.
After the beverage system is fully drained,
press the ON/OFF button to the OFF (O) position.
Problem Cause / Solution
I’ve primed the pump. Priming water has been
dispensed. The red indicator light continues to ash.
It may take several times to properly prime the pump.
➤
Repeat the priming procedure. The unit will beep
twice to indicate the pump is primed. When all 6
beverage buttons are illuminated (and not ashing)
and the red indicator light is o; the beverage system
is heated and ready for use.
The brewed beverage is not hot enough. Cold cup or mug.
Scale build-up in the beverage system.
➤
Preheat the cup or mug.
Descale the beverage system monthly.
The lever cannot be lowered. The used capsule drawer is full.
There is a capsule lodged in the capsule compartment.
➤
Slide out the used capsule drawer; dislodge and
remove the used capsule. Replace drawer.
The beverage system will not brew. Used capsule in drawer.
➤
Slide out the used capsule drawer; dislodge and
remove the used capsule. Replace drawer.
Beyond the recommended cleaning and maintenance procedures, the CBTL® machine is not user serviceable.
For additional options, please refer to the Limited Warranty.
To Next Page
Loading...
