Press the ON/OFF button to the ON position. All 6 beverage
buttons and the red indicator light will begin to ash.
IMPORTANT: Make sure the capsule lever is
lowered to its original position.
1
Before First Use: Prime the Pump
Place a cup or mug onto the drip tray.
Fill the water tank. There are 3 ways:
• remove the water tank cover
• ip the water tank lid open to use a spouted container
• pull the water tank up and out of the unit using the side
grips to remove.
Fill water tank with cool, clean water (it is STRONGLY
recommended you use DISTILLED WATER) to the MAX water
ll line. Make sure water tank is closed and locked properly
into position before proceeding.
Unpack the beverage system and
remove all packaging materials.
Plug the power-supply cord into a
grounded 3-prong electrical outlet.
Prime the Pump. Press any beverage
button. After a moment, the pump will
operate. The priming process will take
about 2 minutes.
To Next Page
Loading...
