CBTL 10134 - Confirming Priming and System Readiness; Brewing Beverages; Preparing for Brewing

8
7
6.5
8
The unit will beep twice to indicate the pump is
primed. When all 6 beverage buttons are illuminated
(and not ashing) and the red indicator light is o; the
beverage system is heated and ready for use.
IMPORTANT: If the red indicator light
continues to ash, repeat the priming
procedure. It may take several times to
properly prime the pump.
Empty the cup or mug. Slide out the used capsule drawer
and empty any priming water. Replace the drawer. Place the
empty cup or mug onto the drip plate. When all lights stop
ashing, the beverage system is heated and ready to brew.
1
3
2
4
Make sure the water tank is lled, but
does not exceed the MAX water ll line.
Make sure the power-supply cord is
plugged into a grounded 3-prong
electrical outlet and the power ON/OFF
button is in the ON position.
Check to make sure the capsule drawer is empty.
Raise and lower the capsule lever to eject any used
capsule into the drawer. Pull the used capsule
drawer out, remove capsule (if any) and slide
drawer back into place. Test to make sure drip tray
is properly and securely turned/locked in position at
the appropriate level. Add the drip plate and place
an empty cup or mug under the dispensing spout.
CAUTION: Capsule may be hot.
Use care when handling.
All buttons will ash as the unit begins to heat.
When all 6 beverage buttons and the red indicator
light are illuminated (and not ashing); the
beverage system is heated and ready to brew.
1
2
Before First Use: Prime the Pump (continued)
Brewing Beverages
Each coee and tea capsule features an internal double ltration system to ensure evenly balanced extraction and optimal avor.
Every serving of espresso, coee and tea is freshness-sealed to lock in its exquisite taste and aroma.