Need help?Do you have a question about the CCi CNA1000 and is the answer not in the manual?
Details of connectors and indicators on the front.
Details of connectors and indicators on the rear.
Pin assignments for RJ45 serial ports.
Pin assignments for DB25 serial ports.
Details on Ethernet and optically isolated I/O ports.
Pin assignment for the DC power connector.
Standard communication settings and network defaults.
Default IP address, subnet mask, and gateway.
Purpose, connection, and initial startup of the configuration tool.
Main screen layout, menus, and configuration options.
Processor, memory, interfaces, power, and environmental specs.
Details on the product's limited warranty period.
Mailing address and phone for the corporation.
Contact information for technical support and service.
General Specifications| microprocessor | Rabbit 3000 @ 44.2 MHz |
|---|---|
| SRAM | 512K pgm + 512K data |
| flash memory | 512K + 4 Mbyte serial |
Network Interface| ethernet port | 10/100 auto-sensing, RJ45 jack |
|---|
Serial Interfaces| serial ports | 5 each |
|---|---|
| maximum asynchronous data rate | 115.2 kb |
| maximum synchronous data rate | 230.4 kb |
Analog Interfaces| analog inputs | 2 each, optically isolated |
|---|---|
| analog outputs | 2 each, optically isolated |
Electrical| power | 9-18 VDC, 1W typical |
|---|---|
| DC isolation | 2000 VRMS minimum |
Physical / Environmental| operating temperature | -40°C to +70°C |
|---|---|
| humidity | 5% to 90% non-condensing |
| dimensions | 7.13” x 2.35” x 4.88” (181.1 x 59.6 x 124.0mm) |
To Next Page