Press #
Press # again
Press UP / DOWN Key to select the “All Cases”
Press 6 to Enable / Disable (If enabled, SMS will be sent/received in all events. If Disabled then in no
case SMS will be sent/received on that Telephone number)
Press #
Quick Exit
Press “UP” or DOWN” to set the next /previous Telephone number
Repeat the above steps for all the Telephone numbers
To configure Telephone numbers for SMS in selected events:
Press Key “3”
Enter Master Password (1234) + #
Press “UP” or DOWN” to select the telephone number.
Press #
Press # again
Press UP / DOWN Key to select the event
Press 6 to Enable / Disable
Press #
Press UP / DOWN Key to select another event
Press 6 to Enable / Disable
Press #
……………………… continue for various events
Quick Exit
Press “UP” or DOWN” to set the next /previous Telephone number in location 1 to 6.
Repeat the above steps for all the Telephone numbers
Note: The Telephone numbers are dialed by the system as per the sequence number 1 to 6.
: The display sows 2 Alphabets (AB) at the end of each Telephone number entered.
A = Y means “SMS feature” is available on that Telephone number.
= N means “SMS feature” is not available on that Telephone number.
B = Y means “Command feature” is available on that Telephone number.
= N means “Command feature” is not available on that Telephone number.
: If no Telephone number is entered, the system cannot be ARMED.
Deleting a Telephone number
Press Key “3”
Enter Master Password (1234) + #
Press “UP” or DOWN” to select the telephone number to be deleted.
Press # + Back Space
Press #
. Telephone Number Redial Times .
To set the number of times the system should dial each of the 6 Telephone numbers, following is the programming:
Press “SET”
Enter Master Password (1234) + #
Keep Pressing 2 to select “Redials”
Press # + Back Space
Press 01 to 15 + # + Quick Exit
Where, 01 to 15= No of Times to Redial
Note: If 3 is entered then System will dial each Telephone Number 3 times unless any of the called party dials # or
DISARMS by dialing 5.
: In default the number of Redial Times = 02
: If value entered is greater than 15 then system will accept the same but store it as 15.
. Telephone Number Display - ON / OFF .
Telephone Numbers being dialed by the system during intrusion are displayed on the Main Unit. This display can be
cancelled with the following programming.
Programming:
Press “SET”
Enter Master Password (1234) + #
Keep Pressing 2 to select “Tel Display”
Press #
Press key “UP” or “DOWN” to select ON / OFF
Press # + Quick Exit
Note: It is OFF in default.
. Voice Message Recording for playing on Telephone calls during Intrusion - Optional .
Voice message which the system plays after dialing Telephone number, during intrusion.
Programming for recording of message:
Press “SET”
To Next Page
Loading...