q= name of system (up to 15 characters). This name
will be used in SMS sent to users & CMS.
Arms the system even if a sensor is left open.
dd = date, mm=month , yy=year , j = day
(Mon=1…Sun=7), hh=hours, mm = minutes
No. of rings to pick up
incoming call
n= number of rings to be assigned (1 to 8)
Displays all the sensors which are open
All data will be erased except the Telephone
Numbers and their SMS configuration.
Note: Messages are case sensitive. Enter in Capital letters only.
: XXXX in the above table refers to 4 digit Password
Programming by Android Application:
The free android application named ‘BAS-G’ is available on Google Play Store.
Steps to add your BAS-G panel in the application are as follows:
Press ‘LOGIN’ displayed on home screen of app
Press ‘ADD’
Enter System Name- a suitable name for the BAS-G System
Enter System Number- the number of SIM Card installed in BAS-G
Press ‘DONE’
The system name will now be displayed on the app.
Similarly, multiple systems can be added by pressing the ‘ADD’ option on top right corner
On pressing the name, you are shown options to Arm, Disarm, By Pass Arm, etc.
Press the desired option, and enter your password for the BAS-G panel.
For all other programming, press ‘Settings’, choose the desired programming, and enter your password to
Confirm
A confirmation SMS for the same will be received from the panel.
Wireless Sensor Type Table
. Telephone Numbers Entry & SMS Controls .
User can enter up to 6 telephone numbers that can be dialed by the system. Each Telephone number can be
individually configured for:
Sensing & receiving SMS in selected events only.
You can set a Telephone number for SMS in all events (i.e., ARM, DISARM, PANIC, Batt. Low, Tamper, Intrusion, etc
+ user can send SMS from that Telephone number to ARM, DISARM, Change Pass Word, etc). After setting the
Telephone number for all events, you can disable selected events. Similarly you can Disable all events and enable
selected events.
To enter Telephone numbers that are to be dialed during intrusion:
Press Key “3”
Enter Master Password (1234) + #
Press “UP” or DOWN” to select the telephone number.
Press # + Back Space
Enter the Telephone number (Whenever Country code is used, make sure to add + before the country
code. “+” can be added through “” Key).
Each Telephone number can be of maximum 16 digits.
Press #
Quick Exit
Press “UP” or DOWN” to set the next /previous Telephone number in location 1 to 6.
Repeat the above steps for all the Telephone numbers
To configure Telephone numbers for SMS to be sent / received in all events or in NO event:
Press Key “3”
Enter Master Password (1234) + #
Press “UP” or DOWN” to select the telephone number.
To Next Page
Loading...