EasyManuals Logo

CDA FW552 User Manual

CDA FW552
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Changing the light bulb
Disconnect the appliance from the power.
Carefully remove the light cover by pushing in the lever at the back
of the cover, and then pulling the cover down.
Unscrew the light bulb to remove it and replace with a new bulb
(15W max).
Replace the light cover and reconnect the power after five minutes’
delay as explained on page 3.
Troubleshooting
If you have any problems with your appliance, you should check
the troubleshooting prior to calling CDA Customer Care to prevent
unnecessary service calls and potential cost.
If the appliance is not working
Check there is power to the appliance:
The house fuses are intact and the fuse in the plug has not blown.
The thermostat is not set to 0 (o position).
The plug socket is functioning fine. To check this, plug another
electrical appliance in to see if the socket is working.
The appliance is working, but not very well
The appliance is not overloaded.
The thermostat is set to an appropriate temperature.
The door is closing properly.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CDA FW552 and is the answer not in the manual?

CDA FW552 Specifications

General IconGeneral
BrandCDA
ModelFW552
CategoryRefrigerator
LanguageEnglish

Related product manuals