BIOSYS 1
PROGRAMMING
SETTING THE MASTER CARD
1
Orange LEDs
ashing
LEDs turn to solid
green (master
card approved)
then turn to blue
(Standby mode)
2
3
Reader is connected to
the remote controller
Swipe the master card
ADD USER
1 2
Swipe the master card Swipe the user card
One audible
beep is emitted
and the green
LED ashes
slowly
Orange LEDs
ashing and
three audible
beep are emitted
One audible beep
is emitted and the
green LED ashes
faster
Place your nger
on the sensor. One
beep is emitted and
the LED turn to solid
green for a second.
Remove your nger.
The green LED starts
to ash rapidly again.
Repeat the operation
four more times.
3
Place and remove
your nger on the
sensor ve time
The master card is not
programmed if the red LED
activates for 1 second. Refer
to «Setting the master card»
section.
The user card is already
programmed in the reader if the
red LED activates for 1 second.
Try another user card.
TO DELETE MASTER CARD
In the remote electronics, put Dipswich 1 to ON for 1 sec., then OFF.
The template/users remain programmed.
Blue : Standby mode.
Red : Access denied or invalid programming
Green : Access Granted or acknowledgement
Orange : Programming mode.
The ngerprint has not been
enrolled if no audible feedback is
emitted. Repeat steps 1, 2 and 3.
BIOSYS 1 LED Status Indicators
! ! !
To Next Page
Need help?
General
