DGPROX
PIN Code and/or Badge
STAND-ALONE PROXIMITY SYSTEM
32 V1 E M B OCT5 12
RL1RL2
3
2
1
ST1 ST2
1 3
I1
PB1
V1
Input voltage
12V ~ or =
230V~
strike
12 V 1 4 5 3 2
Wiring diagram
PCB front view
This device comes with a varistor.
The varistor must be connected on the strike terminal
(electromagnet…) operated by the device.
If this product operates more than one strikes, each of them
should have a varistor.
The varistor controls the overload produced by the strike coil –
B Request-to-exit PB1
E Alarm Input
M Common PB1, E and 4
O Relay 1 contact
C Common
T Relay 2 N/O contact
I1 Anti-tamper switch
V1 Varistor
ST2
Jumper for reset
Jumper for relay 1
RL1 Door relay
RL2 Alarm relay
12 Power
supply
V Po
wer supply
1 Data
2 Buzzer
3 Green LED
Auxiliary reader
Do not use a
switching
power supply
because of the
interference
radiation that
may disturb
the reading of
the badges
N/C contact RL1 (magnet)
N/O contact RL1 (strike)
See wiring diagram auxiliary reader
ST2
1
3
1 3
If you are using a « Shear Lock » electromagnetic lock, it is recommended to use a
separate power supply than the one connected to the DGPROX.
To Next Page
Need help?
General
