CDVI CDV-DDP - Page 12

Basic Tools Detail:
Item Description
Factory
set
IDCode
Ifonlyonedoorstationisinstalledinthisbuilding,set
to0;
Ifmultidoorstationsareinstalled,primarydoorstation
mustbesetto0,andotherslavedoorstationsmust
besetfrom1to3.Notethatmax.4doorstationsare
availableinonebuilding
[0]
Single
UnlockTiming
Tosetthetimethathowlongthedoorkeepsopen
whendoorisreleased.Rangefrom01to99seconds.
[05]
5seconds
UnlockOutput
Tosettheunlockmodetomatchthecorresponding
lock.Rangefrom0to1.
0:Power-on-to-UnlockMode(NormallyOpenMode)
1:Power-off-to-UnlockMode(NormallyClosedMode)
0
CardManage
Tosetthecardlocation.Ifsetto0,thecardissavedin
doorstation.Ifsetto1,thecardissavedinDT-IPC
0
DoorplateMode
Tosetthecallingmode.Ifsetto0,it'stheauto
mode,thatmeansthecallingwillbeactivateddirectly
afterinputting2digitscode.Ifsetto1,it'sthemanual
mode,thatmeansyoushouldpress"#"buttontoacti-
vatethecallingafterinputtingthecode.
[0]
Automode
AudioOptions...
Tosettalkingmode,whencuttingvoiceormixedvoice
appears,setto1.
DS-IMtalking:setthevoicematchingbetweenDoor
StationandIndoorMonitor
DS-NTtalking:setthevoicematchingbetweenDoor
StationandGuardUnit
0
Parameters... Toshowtheparameters,pleaserefertotable2.1
InstallerCode... Tochangedoorstationadministratorcode [66666666]
Default...
Note thisoperationis irreversible.Oncerestoreis
activated,allparameterswillreturntofactorydefault
settingexcepttheinformationofaccesscard.
Table2(InstallerSetup):
-10 -