Need help?Do you have a question about the Cebora Power Tig 1540 DC-HF and is the answer not in the manual?
General| Power Supply | Inverter |
|---|---|
| Input Voltage | 230 V |
| Frequency | 50/60 Hz |
| HF Start | Yes |
| Rated Input Power | 5.5 kVA |
| Type | TIG |
| Welding Process | TIG |
| Input Phase | 1 |
| Output Current Range | 150 A |
| Duty Cycle | 60% |
Diagnostic procedures for common issues encountered with the power source.
Troubleshooting steps when the power source fails to start or the control panel is off.
Troubleshooting when the start button in TIG operation has no effect.
Diagnostic steps for when no gas flows from the torch during TIG operation.
Troubleshooting when gas flows but the arc does not start, with missing high frequency.
Procedure to test and resolve irregular output voltage in open circuit operation.
Procedure to test and resolve irregular output voltage during resistive load operation.
Troubleshooting for unstable arc or irregular welding quality in TIG operation.
Indication of temperature above limits, fan operation, and cooling recommendations.
To Next Page