Need help?Do you have a question about the Cebora POWER ROD 1350 and is the answer not in the manual?
General| Input Voltage | 230V |
|---|---|
| Input Frequency | 50/60 Hz |
| Rated Input Power | 3.2 kVA |
| Insulation Class | H |
| Electrode Diameter | 1.6 - 3.2mm |
| Protection Class | IP21 |
Manual's purpose is to train personnel for maintenance on power source art. 249 for MMA and TIG welding.
Customer/operator responsibility for equipment use, maintenance, and qualified personnel for repairs.
Safety notes are integral. Disconnect power, wait for capacitor discharge before accessing internals.
Instructions for electromagnetic compatibility are in the Instruction Manual.
POWER ROD 1350 is MMA/TIG welding system with contact arc start, controlled by microprocessor.
Technical specifications are found on the machine plate, Instruction Manual, and Sales Catalogue.
Art. 249 is a voltage power source with controlled current, single-phase rectifier bridge and DC/DC converter.
Ensure proper airflow, remove dirt, check output terminals/cables, and internal power connections.
Procedure for correct functioning and troubleshooting, to be carried out after each repair.
Guides for diagnosing and resolving common operational issues and error codes.
Explanation of error codes indicated by the yellow LED (B) status.
Reference to external file ESP249.pdf for Power source art. 249 details.
Reference to external file ESP249.pdf for components table.
List of essential and recommended spare parts for the power source.
Reference to external file SCHE249.pdf for electrical diagrams of power source art. 249.
Details for Power board (15) code 5.602.018/B, including topographical drawing and connector table.
To Next Page