To Next PageTo Next Page
Need help?Do you have a question about the Cebora PLASMA PROF 122 and is the answer not in the manual?
Procedures for unpacking and assembling the plasma cutter unit.
Instructions for correctly attaching the torch to the plasma cutter.
Identification and explanation of the various components of the plasma cutter.
Details on technical specifications and international standards compliance.
Steps and precautions for initiating the plasma cutter's operation.
Overview of the built-in safety mechanisms within the plasma cutter.
Method for using the plasma cutter for gouging operations to remove material.
Guidelines for operating the plasma cutter with the P70 torch model.
Addresses issues where the plasma arc does not cut deep enough.
Explains reasons for the plasma cutting arc failure or interruption.
Provides solutions for cuts that are not perpendicular to the workpiece.
Discusses causes of premature wear on torch consumables.
Using a drying filter prevents oxidation, wear, and quality issues from moisture.
Instructions for replacing parts like electrode, diffusor, and tip.
Safety measures and checks required after performing maintenance or repairs.
Critical safety information and rules to prevent electrical hazards.
Warnings about ultraviolet radiation and necessary protective measures.
Health risks from cutting fumes and required safety precautions.
Safety guidelines to prevent fires caused by plasma cutting operations.
Precautions to avoid skin burns from arc, sparks, and hot metal.
Safety measures to prevent explosion risks during cutting operations.
Information on noise levels and necessary safety precautions.
Warnings for individuals with pacemakers regarding magnetic fields.
General| Input Voltage | 400V |
|---|---|
| Input Current | 16A |
| Duty Cycle | 60% |
| Protection Class | IP23 |
| Power Supply Voltage | 400V |
| Frequency | 50/60Hz |
| Pilot Arc Current | 15A |
| Air Pressure | 5.5 bar |
| Current Range | 30-120A |
