SE15 OPERATIONS MANUAL & PARTS LIST (Rev. 8/2020)
4.3.2.2 – INSTALLING FILTER
1. LOOSEN THE TWO WING NUTS ON THE FILTER LID AND REMOVE LID.
2. PLACE BOTTOM END OF FILTER SLEEVE IN FILTER.
3. FOLD UPPER 1 ½” OF FILTER SLEEVE COLLAR OUT OVER LIP OF FILTER
SO THAT THE GASKET IN LID WILL CLAMP IT IN PLACE.
4. REPLACE FILTER LID AND TIGHTEN WING NUTS SECURELY.
5. SUSPEND FILTER FROM HOIST OR FORKLIFT. OPEN FILTER DOOR.
6. PULL BOTTOM END OF FILTER SLEEVE DOWN AND FOLD UP LOOSELY
SO THAT BOTTOM END OF SLEEVE WILL BE CLOSED.
7. PLACE FILTER IN SUMP CLEANER AND TIGHTEN THE WING NUTS
SECURELY.
To Next Page
Loading...
Need help?
General