cecotec 830 COOLCRYSTAL - Page 25

BOLERO GRANDSOMMELIER 830 COOLCRYSTAL/ COOLWOODBOLERO GRANDSOMMELIER 830 COOLCRYSTAL/ COOLWOOD
4948
ENGLISH ENGLISH
Temperature unit selection
Touch the Temperature Unit Selection and Light On/O icon for 2 seconds (approx.) to switch
between degrees Fahrenheit (°F) and degrees Celsius (°C).
Light on/o
Touch the Temperature Unit Selection and Light On/O icon to switch the interior light on or
o. Touch the icon again to turn it o. The light will automatically switch o after 10 minutes.
Locking the control panel
- The control panel has an automatic locking system that activates after 20 seconds of
inactivity (without touching any icons).
- Touch the unlock icon for 2 seconds (approx.) to unlock the control panel. A beep will sound,
indicating that the control panel is unlocked.
- All icons will be inactive after locking the control panel.
NOTE:
Upon rst switch-on of the wine cooler or after a period of inactivity, there may be a
considerable dierence between the selected temperature and the temperature indicated on
the control panel. This is normal, and the appliance will reach the selected temperature after
a few hours of operation.
5. STORAGE TIPS
- This appliance is intended to be used exclusively for wine preservation.
- Wine coolers are designed to store a maximum of 8 standard-size bottles (750 ml capacity
Bordeaux), with 2 bottles per shelf.
- You can store larger bottles, as long as they do not prevent the door from closing properly.
- Capacity can vary depending on storage method or bottle size.
Wines and suggested temperatures:
Temperature (ºC) Temperature (ºF)
Red wine 14-18 57-64
Dry/white wine 9-14 48-57
Rose wine 10-11 50-52
Sparkling wine 5-9 41-48
below to ensure proper heat dissipation:
1. Leave at least 200 cm
3
of free space around the appliance.
2. Leave at least 20 mm of free space between the wine cooler and the rear wall.
3. Leave at least 50 mm of free space between the sides of the appliance and other walls
of devices.
1. Ensure constant air circulation around the wine cooler.
- Place the appliance on a solid, at surface to keep it stable, or vibrations and noises will
occur. Make sure that the appliance is level by adjusting the height with its legs. If possible,
do not place the appliance directly on the ground.
- Wait at least 2-3 hours before plugging the appliance into a power outlet and storing
bottles inside. Clean the inside with a soft cloth and lukewarm water. Check that the
shelves are correctly positioned.
- Installation is recommended in a location with an ambient temperature between 16 and
32 °C. A lower or higher temperature than indicated may aect optimal operation of the
appliance.
- It is not advisable to use the wine cooler if ambient temperature is below 10 ºC.
- A water container can be placed inside the appliance to maintain humidity.
4. OPERATION
This appliance has a temperature control on the front. You can adjust the temperature between
8 and 8 °C (46-64 °F). The internal temperature may be aected by factors such as the location
of the appliance, the ambient temperature, the door opening frequency, etc.
Control panel. Fig. 2
1. Unlock icon
2. Temperature Unit Selection and Light On/O icon
3. Temperature indicator
4. Temperature increase icon
5. Temperature decrease icon
Switch-on
Plug in the appliance. Set the desired temperature using the temperature increase or decrease
buttons.
Please note
After setting the temperature, the temperature display will show the internal temperature of
the appliance, which will gradually change until the set temperature is reached.