cecotec BIGDRY 4000 EXPERT - Operation; Basic Operation Controls; Draining Collected Water; Continuous Water Drainage

BIGDRY 4000 EXPERT/BLACKBIGDRY 4000 EXPERT/BLACK
17
ENGLISH
4. OPERATION
The power light indicator will turn on when the unit is plugged in,
regardless of whether the unit is operating or not.
Press the power button once to start operation. Press it again to stop operation.
Press the high-low speed button to activate the fan function. Press the same button to
select between high or low speed.
Press the settings button to set the desired room humidity level. Set from 40 % to 80 %,
in 5 % intervals.
Note: After the device has been operating for some time, if the environment humidity
is lower than the set value by 2 %, the device will stop operating after 3 minutes. If the
environment humidity level is equal to or higher than the selected humidity by 2 %, the
device will automatically start operating again.
Draining collected water (Img.5)
When the water tank is full, the tank full indicator light will turn on, the device will stop
operating automatically and it will beep 15 times to alert the user that the tank’s water
needs to be emptied.
How to empty the water tank:
Lightly press on the sides of the tank with both hands and pull the tank out gently.
Empty water inside the tank.
Note: (Img.6) Do not remove the oat from the water tank. The water-full sensor will no
longer be able to detect the water level correctly without the oat and water may leak
from the water tank.
(Img.7) To install the tank back in place, press it rmly into place with both hands. If the tank
is not positioned properly, the “TANK FULL” sensor will be activated and the dehumidier
will not operate.
Continuous water drainage (Img.8)
The unit features a continuous-drainage port. Using a plastic pipe (with an inner diameter
of 10 mm), insert it into drain hole (on intermediate plate), reach out from side of water
tank, install it in place, and arrange the drain pipe.
The water in the tank can be continuously drained out from the continuous port on the unit.
5. CLEANING AND MAINTENANCE
Turn off and unplug the product from the power supply before cleaning or repairing it.
Use a soft, damp cloth with some neutral cleaning agent to clean the product’s outside.
If the product is not going to be used for a long time, pour out the remaining water, dry
thoroughly all the parts and store it in a safe and well-ventilated place.