cecotec BIGDRY 4000 EXPERT - Cleaning the Filter; Storage Instructions; Troubleshooting; Unit Does Not Work

18
BIGDRY 4000 EXPERT/BLACK
ENGLISH
If the water tank is dirty, wash it with cold or lukewarm water. Do not use detergent,
scouring pads, chemically-treated cloths, gasoline, benzene, thinner, or other solvents, as
these can scratch and damage the tank and cause water leakage.
Cleaning the lter
(Img.9) Open the lter compartment and remove the lter.
(Img.10) Run a vacuum cleaner lightly over the surface of the air lter to remove dirt. If the
air lter is exceptionally dirty, wash it with warm water and a mild cleanser. Dry thoroughly.
To attach the air lter, insert it into the grill smoothly, and place the compartment into its
right place. (Img.11)
Storage
Before storing the device for a long period of time:
Empty any water left in the tank.
Wind the power supply cord and put it in the water tank.
Clean the lter edge.
Store it in a cool and dry place.
6. TROUBLESHOOTING
Problem Possible cause Solution
The unit does not work
Has the power cord been
disconnected?
Plug the power cord into the
outlet.
Is the tank full indicator
on? (The tank is full or not
installed properly)
Empty the water in the tank
and then reinstall the tank.
Is the temperature of the
room above 35 or below 5 ?
The protection device is
activated and the unit cannot
operate.