27
ENGLISH
BIGDRY 5000 ADVANCE
Remove the water tank from the device.
Pour out the water inside it.
Install the water tank back again into the dehumidier.
4. OPERATION
Control panel
Power button
Use this button to switch the device on and off.
Mode buttons
Press this button to select a mode. The current mode’s button will ash. The device has
four modes: Dehumidication, Automatic dehumidication, Forced dehumidication and Dry
clothes. Press the corresponding button to the function you want to activate and, after 5
seconds, it will enter the selected mode.
Air-speed button
Set then air speed to “low” or “high”. The corresponding indicator light will turn off.
Timer button
Set a timer from 1 to 24 hours. The device will automatically exit this mode if the user chooses
“0” or after 5 seconds of no operation.
Press this button to activate the timer and press it repeatedly to check the selected time.
After the timer has been set, press this button again to display the remaining time.
Humidity setting
Set the humidity percentage by pressing this button. It goes from 30 to 80, from 5% to 5%.
Air Clean function
Press this button to turn the Air Clean function on.
Child-safety lock
Press this button to activate the child-safety lock.
Mode’s description
Dehumidication mode
If the humidity is 3% lower than the set humidity, this function will turn off automatically. If it
is 3% higher, it will turn on automatically.
Auto dehumidication
To Next Page
Loading...
Need help?
General
