28
ENGLISH
BIGDRY 5000 ADVANCE
Sets the humidity to 55%.
Forced dehumidication
In this mode, humidity cannot be set and the air speed cannot be modied.
Rapid drying
In this mode, humidity cannot be set and the air speed cannot be modied.
Ventilation
Humidity level cannot be set and adjustable speed.
Sleep mode
Reduces the noise the device makes when operating.
5. CLEANING AND MAINTENANCE
Disconnect the appliance from the power supply and allow it to cool down before cleaning.
Use a soft, damp cloth to clean the product’s surface. Cleaning the device with a product
containing chemicals may change the color of the unit.
Do not immerse the appliance in water or other liquid.
Do not use abrasive scouring pads, powders or cleaners.
Make sure your hands are dry before handling the plug or switching on the appliance.
If the device is not going to be used for an extended period:
Empty the water in the tank and remove it, then clean it and dry it and assemble it back.
Clean the lters.
Place the device upright and avoid direct sunlight.
Cleaning the lter
Fig. 5
We recommend doing this every two weeks.
The device’s capacity may be reduced if the lter is clogged.
Continuous water drainage
The unit features a continuous-drainage port. Using a plastic pipe (with an inner diameter of 10
mm), insert it into drain hole (on intermediate plate), reach out from side of water tank, install
it in place, and arrange the drain pipe.
The water in the tank can be continuously drained out from the continuous port on the unit.
To Next Page
Loading...
Need help?
General
