BIGDRY 9000 PROFESSIONAL/BLACK CONNECTED
33
ENGLISH
Note: Do not remove the oat from the water tank. The water-full sensor will no longer be able
to detect the water level correctly without the oat and water may leak from the water tank.
Fig. 7
To install the tank back in place, press it rmly into place with both hands. If the tank is not
positioned properly, the “TANK FULL” sensor will be activated, and the dehumidier will not
operate.
Fig. 8
Continuous water drainage
The unit features a continuous-drainage port. Using a plastic pipe (with an inner diameter of 10
mm), insert it into drain hole (on intermediate plate), reach out from side of water tank, install
it in place, and arrange the drain pipe.
Fig. 9
The water in the tank can be continuously drained out from the continuous port on the unit.
4. CLEANING AND MAINTENANCE
Turn off and unplug the product from the power supply before cleaning or repairing it.
Use a soft, damp cloth with some neutral cleaning agent to clean the product’s outside.
If the product is not going to be used for a long time, pour out the remaining water, dry
thoroughly all the parts and store it in a safe and well-ventilated place.
If the water tank is dirty, wash it with cold or lukewarm water. Do not use detergent, scouring
pads, chemically-treated cloths, gasoline, benzene, thinner, or other solvents, as these can
scratch and damage the tank and cause water leakage.
Cleaning the lter
Open the lter compartment and remove the lter.
Fig. 10
Run a vacuum cleaner lightly over the surface of the air lter to remove dirt. If the air lter is
exceptionally dirty, wash it with warm water and a mild cleanser. Dry thoroughly.
Fig. 11
To attach the air lter, insert it into the grill smoothly, and place the compartment into its right
place.
Fig. 12
Storage
Before storing the device for a long period of time:
Empty any water left in the tank.
Wind the power supply cord and put it in the water tank.
Clean the lter edge.
Store it in a cool and dry place.
To Next Page
Loading...
