cecotec Conga 8090 Ultra - Remote Control Cleaning Modes; Power Level Adjustment via Remote; Manual Control and Scheduling Setup

CONGA 8090 ULTRA | 33
ENGLESK
If not, press any button on the remote control to wake it up.
Automatic mode. Fig. 14.
- Press the power button on the remote control for it to start cleaning
automatically, rst a cleaning cycle in Edge mode and then another cycle
in an organised zigzag motion, recognising which areas it has cleaned and
which ones it has not. The robot will automatically plan the cleaning route
as it is cleaning. If during this mode the robot is controlled manually, the
robot will calculate the route again and could go through previously cleaned
areas. In order to ensure ecient cleaning, do not operate it manually during
auto mode cleaning.
- Thanks to its Total Surface 3.0 technology, if the battery is low during
the cleaning cycle, the robot will smartly return to the charging base
automatically and, once it is fully charged, it will resume the cleaning
process from the same point, oering a high-eciency cleaning.
During cleaning, the robot will stop briey to evaluate the area and calculate
the cleaning route (this stop will vary depending on the house conditions).
Note
The robot cleans in an organised way and per 4x4 m squared areas, therefore
it might leave the room where it is cleaning to nish o the delimited area.
Do not worry, the robot will clean all the accessible surface.
Edge mode. Fig. 15.
Press the Edge mode button on the remote control for the robot to start
cleaning under this mode. It will automatically start cleaning along all the
surface’s perimeters and then will return to the charging base direct and
automatically. If the robot has not started cleaning from the charging base,
it will return to the starting point.
Note
Press the power levels button to switch between the 3 modes: Turbo/
Normal/Eco.
Back home Mode. Fig. 16.
- Press the Back home button on the remote control in order to send the
robot to the charging base. This function can be activated during any other
cleaning cycle and the robot will automatically return to the charging
base and stop the cleaning process. The robot will take the shortest route
back to the charging base thanks to its map memorizing and the smart
back home function.
- When a cleaning cycle has been completed or the robot’s battery is low,