cecotec CONGA ASH 2000 COMPACT - Assembly and Operation; Cleaning and Maintenance; Troubleshooting

Conga Ash 2000 Compact/ 3000 Compacto Plus/4000 Advance
43
ENGLISH
3. ASSEMBLY AND OPERATION
Fig. 3
1. Install the high eciency lter on top.
2. Set the upper part of the vacuum cleaner on the tank.
3. Set the exible hose in the suction opening.
4. Install the desired nozzle on the other end of the exible hose.
5. To start vacuuming, switch on the appliance and press the power switch.
6. If you want to use the blowing function, simply connect the exible hose to the relevant
hole.
7. Always unplug the appliance after each use.
4. CLEANING AND MAINTENANCE
Fig. 4
1. Open the dust tank.
2. Remove the high-eciency lter.
3. Shake the dust out of the high-eciency lter to clean it.
4. Empty the dust tank.
5. Wash the high-eciency lter with clean water if necessary.
6. Please note: Before reinstallation, be sure to dry the high eciency lter completely if it
has been previously washed with water.
7. Put the lter and canister back in place inside the vacuum cleaner.
WARNING:
The surface of the device may only be cleaned with a dry or damp cloth.
5. TROUBLESHOOTING
Problem Possible cause Solution
The motor does not
start
- The power cord is not
plugged into a socket.
- The power socket is
damaged.
- The vacuum cleaner was
not switched on.
- Properly plug in the device.
- Check that the socket is not
damaged.
- Switch the device on.
08118 Conga Ash 2000 Compactindd.indd 4308118 Conga Ash 2000 Compactindd.indd 43 19/6/23 17:4019/6/23 17:40