CONGA GRASSHOPPER 300
121
ENGLISH
LED indicator
lights
Meaning Action required
No indicator
light is on
The charging station is
not connected to the
mains.
Check that the power cable is properly
connected to the charging station, and that
the charging station is connected to a suitable
power supply.
Steady green The boundary wire is
correctly connected.
This is normal, no action is required.
The battery is fully
charged.
Flashing
green
The mower is charging. This is normal, no action is required.
Flashing red The boundary wire is not
connected or is damaged.
Check that both ends of the boundary wire are
securely connected.
Check the boundary wire for damage.
4. OPERATION
1. Once the installation process is completed, the mower will be ready for use.
2. Press the button until the mower switches on. The rst time you do this, enter the
default PIN code (0000). To do so, press four times until number 0 ashes, as shown
in Fig. 9. (See section “Changing the PIN code” if you wish to change it).
Note:
- The mower will switch o after 30 seconds if no operation is performed.
- If an incorrect PIN is entered ten times, the mower will beep and then switch o. You can
try to enter the PIN again after 50 minutes.
- The robot needs the correct PIN to charge.
- While the robot is charging, it will stop emitting an electrical signal through the cable.
3. Press and then to start the lawn mower. Before starting the mower, remember to
use the cutting knob to adjust the cutting height (the cutting distance is in relation to the
ground).
4. Press and then for the mower to go back to its charging station.
- The mower will mow the lawn without interruption until its battery level is low. It will then
return to the charging station. When fully charged, if it is within the operating range, it will
automatically restart or remain on the charging station if it is outside the operating range.
To Next Page
Loading...