cecotec CONGA GRASSHOPPER 300 - Troubleshooting

CONGA GRASSHOPPER 300
125
ENGLISH
6. TROUBLESHOOTING
Information shown
on the display
Meaning Action required
E1 The mower is outside
the working area
1. Place it within the area enclosed by
the boundary wire.
2. Check that the red and black
terminals are not connected
backwards.
3. If the error still appears, contact the
ocial Cecotec Technical Support
Service.
E2 The wheels of the
mower are blocked
1. Turn the mower o and place it in an
area where there are no obstacles.
2. Switch on the mower. Press the
button and then .
3. If the error code still appears on the
display, disconnect the mower. Then,
turn it over and check if anything is
obstructing the wheels.
4. If there is, remove it. Next, turn the
mower over again and switch it on.
Press the button and then .
E3 The blade disc is
blocked
1. Disconnect the mower.
2. Turn it over and check if anything
is preventing the blade disc from
rotating properly. If the disc or motor
is damaged, contact the ocial
Cecotec Technical Support Service.
3. Remove any obstructions you nd.
4. Turn the mower upside down and
place it in an area where the grass
height is lower or adjust the cutting
height to a higher level.
5. Switch on the mower. Press the
button and then .