cecotec CONGA GRASSHOPPER 800 CONNECTED - Page 127

CONGA GRASSHOPPER 500 CONNECTED
127
ENGLISH
Changing the mower’s time and programming the operating range
- The mower’s time must be set by pressing and holding the button for 5 seconds for the
mower to follow the programming correctly.
- The default operating range is from 9:00 to 15:00, but you can change it. To do so, press and
hold the and buttons at the same time for 3 seconds. For instance, if you want the
mower to start operating at 13:25, when ashes, use the or buttons to
select the desired time, press the button to conrm the setting. will appear on
the display, and the mower will automatically start operating at 13:25. You will hear a beep
when you do so. Fig. 12
Changing the mower’s operating time per day
- The default daily operating time is 3 hours, but you can change it (the minimum time is 1
hour, and the maximum is 24 hours).
- To do this, hold down the button for 3 seconds. For example, if you want the operating
time to be 06 hours, press the or buttons to select the number (06) and, when
ashes, press to conrm the setting. will appear on the display. The
mower will run for 6 hours a day from the start time you have set. You will hear a beep
when it starts up. Fig. 13
Changing the days of operation per week
- By default, the mower will operate 5 days a week. You can change this setting to 3, 5 or 7
days. For example, imagine you want to select 3 days per week.
- The number “05” will ash. Press the or button to select the desired number (03)
and then press to conrm the setting. The following will appear on the display:
3 = Monday, Wednesday, and Friday.
5 = Monday, Tuesday, Wednesday, Thursday, and Friday.
7 = Monday, Tuesday, Wednesday, Thursday, Friday, Saturday, and Sunday.
By default, the mower will cut the edges skirting the boundary wire on Tuesdays and Fridays.
Remember that if you have the mower congured with 3 cutting days, Tuesday will not perform
edge cutting because it has not programmed that day in its operating range.
Rain sensor conguration
- The mower has a built-in rain detection sensor. It will stop operation by default and return
to its charging station until it stops raining and a preset stipulated time has elapsed.
- To access this menu and activate/deactivate this function, press, and hold the button
for 3 seconds. will appear on the display. Press to access the settings and
select the option ON or OFF on the display by pressing and , and then press to
conrm your selection.