52
Left - down.
Right - down.
Up - down.
- You can also select the automatic spraying mode. The robot will spray every 3 seconds
the water from the tank.
- Remember that the 3-second frequency has been stablished according to the natural
operation of the device, so with the automatic mode, you will get good results.
Cleaning instructions
Step 1. Dry cleaning
- For the rst use, you must use the “dry mode”. Do not activate the spray mode or spray
water/glass cleaner. If the surface to be cleaned has too much
sand, remove the sand previously.
- If the surface to be cleaned has a lot of sand, it could form mud
when spraying. Cleaning would not have an optimum result.
- If you use the machine in sunny days or with low humidity, the
dry mode will get better results.
Step 2. Spraying mode
- Choose the spraying mode. Select the automatic or manual
cleaning mode, according to the desired spraying frecuency
or the areas to be cleaned.
- Remember that if the device cloths are too wet, you may not
get the desired cleaning result. It is recommended to slightly
moisten them.
4. CLEANING AND MAINTENANCE
- Use a soft, damp cloth to clean the product’s outside surface.
- The cleaning cloths are washable and reusable.
- Do not immerse the product in water or put it under running water.
- Do not expose the robot to direct sunlight or high temperatures.
To Next Page
Loading...
