cecotec FORCECLIMA 9050 - Powering On and Off; Basic Operation and Airflow Adjustment; Cooling Mode Operation; Dehumidifier Mode Operation

ENGLISH
31FORCECLIMA 9050
a) Turning on and off
• If the mains power is connected, push the POWER button (8) or the icon (I) on the
remote control to switch the appliance on and off. The appliance can be pre-set. When
you switch it on, the pre-set temperature of 22 °C is shown on the display (4). The low fan
speed is also pre-set.
• The compressor does not immediately switch on once the appliance has been switched
on. It switches on after a delay of approx. 3 minutes to prevent damage to the compressor.
This happens after a restart as well.
b) Basic operating
• Adjust the vertical direction of the airow through air outlet openings (2) with your hand.
Caution! Do not break the fan blades by pressing too hard.
• Adjust the horizontal direction of the air ow horizontally using the movable airow
direction aps .
• Press the MODE button on the appliance (7) or the MODE button on the remote
control to switch between COOL , dehumidier and fan modes.
c) Cool mode
• To select the “COOL“ mode, press the MODE button on the appliance (7) or the
button on the remote control. The light will turn on.
• Press the UP and Down buttons (3, 5) or buttons on the remote control to adjust the
temperature within the 16 °C to 31 °C range.
• Press the FAN SPEED button (2) on the appliance or the button on the remote
control to set a high or low speed. The HIGH indicates a high fan speed. LOW indicates a
low fan speed.
• The air conditioner switches off automatically if the room temperature is lower than the
temperature set. The compressor switches off. The appliance’s fan continues to run. If the
room temperature increases, the air conditioner switches on again
• Keep doors and windows closed during air conditioning. In the event that direct sunlight
shines on the room being cooled, e.g. on windows and doors facing the sun, close any
curtains or blinds.
d) Dehumidier mode
• Press the MODE on the device (7) or the button on the remote control to select the
dehumidier mode. The “DEHUM” indicator will light up.
• The Sleep mode cannot be set while the device is operating in dehumidier mode. During
this mode, it only works at slow speed. It cannot be changed. The temperature setting
cannot be modied either.