cecotec HidroBoost 2400 - 5. Cleaning and Maintenance; Tips for Extending Service Life

ENGLISH
29
HIDROBOOST 2400 HOME&CAR
Fig. 3
NOTE: Rinse the soap bottle with clear water after each use.
4. Final rinse
Start the nal rinse at the bottom and work upward. Make sure the surface is thoroughly
rinsed and that al dirt is removed.
5. Shut down
• Make sure all soap is ushed from the system.
• Turn the motor off.
• Turn the water supply off.
• Once the power and water supply are turned off, press the trigger to depressurize the
device.
WARNING:
• Do not turn the water supply off before turning the motor off. Serious damage could occur
to the pump and or motor.
• Do not disconnect the high-pressure hose from the machine while the device is
pressurized. To depressurize, turn motor off, turn water supply off and squeeze gun
trigger 2-3 times.
TIPS FOR EXTENDING THE PRODUCT’S SERVICE LIFE
• Never operate unit without water.
• Do not use the device with hot water.
• Before adjusting the pulverizing nozzle’s pressure (high-to-low or low-to-high) release
trigger.
• Never operate unit for more than one minute without spraying water.
5. CLEANING AND MAINTENANCE
• Use specic soaps or cleaning agents for pressures washers.
• The machine shall be disconnected from its power source by removing the plug from the
socket-outlet during cleaning or maintenance.
• Do not store the pressure washer outdoors or where it could freeze. The pump could be
seriously damaged.