HYDROBOOST 2000
13
between 0.01 MPa and 0.4 MPa and that the inlet hose is at
least 5 metres long.
- If the device is to be connected to a drinking water supply,
install a disconnector on the water pipe to prevent dirty
water from backing up and entering the drinking water
system. The disconnector shall comply with EN 60335-2-79
ANNEX A.
- Water that has owed through backow prevention devices
is considered non-drinkable.
- This device must not be controlled by external switching
elements such as timers, or connected to electrical circuits
that are continuously switched on and o.
- Release the trigger when switching from high to low
pressure.
- Spray nozzle setting.
- Keep the high pressure hose away from sharp objects. A
burst high pressure hose could cause injury. Inspect the high
pressure hose regularly and replace it if necessary. Do not
attempt to x a damaged high pressure hose.
- Keep all connections dry and o the ground to avoid risk of
electric shock. Do not touch the plug with your hands wet.
- Do not use a higher pressure than that permitted by the
parts of the pressurisation system (high-pressure hose,
connections, etc.). Make sure every component and
accessory is rated to withstand the maximum operating
pressure of the unit.
- The appliance should not be used by children. Children
must be supervised to make sure they do not play with the
appliance.
- This appliance can be used by children aged 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
To Next Page
Loading...
