cecotec HYDROBOOST 2000 - 6. Troubleshooting

HYDROBOOST 2000
69
ENGLISH
6. TROUBLESHOOTING
Problem Cause Solution
Smoke comes out
of the appliance.
Overheating, overloading or
motor failure.
Switch o the device immediately
and contact
the Technical Support
Service of Cecotec.
There is not enough
pressure.
The inlet water lter is
clogged.
Air is entering from the hose
connections to the pump.
The nozzle or discharge valve
is worn or not the correct
size.
Clean the inlet water lter.
Check that the connections and the
locking ring are tight.
Contact the ocial Technical
Support Service of Cecotec.
The pressure
washer does not
turn on.
The unit is pressurised.
The plug is not properly
connected or the socket is
defective.
The extension cord is too long
or short.
The supply voltage is too low.
The thermal safety switch
has tripped.
Press the trigger.
Check the plug,
the socket and fuses.
Remove the extension cord.
Make sure that the mains voltage
matches the voltage stated on the
rating label of the appliance.
Switch o the device and allow it to
cool down.
Pressure uctuates. The pump is sucking in air.
The nozzle is clogged.
The valves are dirty or worn.
Hydraulic seals are worn.
Check that hoses and connections
are tight.
Clean them with the cleaning clip.
Contact the ocial Technical
Support Service of Cecotec.
The motor stops
suddenly.
The extension cord is too long
or short.
The thermal safety
switch has tripped due to
overheating.
Remove the extension cord.
Make sure that the mains voltage
matches the voltage stated on the
rating label of the appliance.