HYDROBOOST 2000
65
ENGLISH
3. PRODUCT ASSEMBLY
- Fit the high pressure hose (5) to the pressurised water outlet of the machine (6).
- Attach the gun (7) to the high pressure hose (5). Before putting the machine into
operation, make sure that the high pressure hose (5) is completely unwound. The hose (5)
should not become entangled while in use.
- Install the spray nozzle (12) or the item to be used.
- Connect the machine to the power supply (8) and water supply (3).
4. OPERATION
Setting the water pressure
The angle of the water jet can be set with the spray nozzle by turning the tip. This will cause
the jet to vary from approximately 0° (narrow high impact jet) to 60° (wide spray jet). Fig .3
This device has 3 modes:
Concentrated mode
The angle of the water jet can be set with the spray nozzle. Rotate the nozzle to select
the direct jet, which has a high impact on the surface to be cleaned and provides thorough
cleaning of concentrated areas. This jet must be carefully used, as it can damage surfaces.
Fig. 4
Note
Pay special attention when cleaning surfaces susceptible to damage, such as vehicle
bodywork or rims, lacquered surfaces, wood, paintwork, etc.
Spray mode
Turn the spray nozzle to select the fan spray pattern to cover large areas. This cleaning mode
oers excellent results without the risk of damaging surfaces. By using a wide spray pattern,
larger areas can be cleaned more quickly. Fig. 5
Turbo mode
Use the 3D TurboFlip nozzle to clean with a turbo mode. Water is distributed in a spiral-
shaped jet. The 3D TurboFlip nozzle combines the power of a direct ject of great impact with
the eciency of a 25º jet. This transforms the concentrated jet into a conical jet that deep
cleans larger areas. Fig. 6.
To Next Page
Loading...
