cecotec HYDROBOOST 2000 - Accessories; 3 D TurboFlip nozzle.; Anti-impurities filter; Cleaning process

HYDROBOOST 2000
67
ENGLISH
- Follow the distance and angle instructions mentioned above.
- Vary the angle of the jet, the type of jet and the distance from the surface to be cleaned
until ecient cleaning is achieved without damaging the surface.
-
Accessories
3D TurboFlip nozzle.
The TurboFlip 3D nozzle, also dened as a rotating nozzle, is a very eective accessory to
signicantly reduce cleaning time. It must be used to clean in the turbo mode explained in the
previous section. This accessory is assembled in the wand.
Anti-impurities lter
This model includes a transparent male connector with a lter which can be assembled with
the hose to prevent the dust from passing. This accessory is assembled in the water outlet
(6).
Cleaning process
The following cleaning procedure will help you organise and ensure you get the best results.
Remember to follow the previous advice.
Preparing the surface
- Clear the area of furniture and check that windows and doors are securely closed.
- Also make sure that plants and trees near the area to be cleaned are protected with a
cloth.
Initial high-pressure rinse
Spray the area to be cleaned with water to clean any dirt that may have accumulated on the
surface. Before pressing the trigger, move the spray nozzle to the spray mode position and
progressively move it to the desired spray position. In this way, you will avoid applying an
excessively direct jet on more delicate surfaces.
Final rinse
Start the nal rinse from bottom to top. Make sure that the surface is well rinsed and that all
dirt has been removed.
Turning o
- Make sure there is no detergent in the system.
- Turn o the motor. Turn o the water supply.
- Once the product and the water supply have been turned o, press the trigger to
depressurise the device.
- After each use, wipe the surface of the pressure washer with a clean, damp cloth.