EasyManua.ls Logo

cecotec Hydroboost 2400 AdvanceClean - Page 70

cecotec Hydroboost 2400 AdvanceClean
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HYDROBOOST 2400 ADVANCECLEAN
70
ENGLISH
360Brush special for wheel rims
This model includes a specic brush for car rims made of bristles, which can remove the
harshest dirt. When using this accessory, water will automatically come out as low-pressure
spray. This accessory is attached to the trigger gun.
EasyClean brush (special for gaskets)
This mode also includes a cleaning brush which, combined with water and soap, helps
remove stains and allows for a more ecient cleaning. When installing and using this
accessory, water will automatically come out as spray, at low pressure. This accessory is
attached to the trigger gun.
2-spin brush (special for oors)
This accessory is installed on the lance of the product and consists of hard bristles. When
activated, it rotates while emitting water at high pressure, making thorough cleaning possible
in the most convenient way. It is designed to clean the patio, garden oor, or oors in general.
Fig. 8
Cleaning process
The following cleaning procedure will help you organise and ensure you get the best results.
Remember to follow the previous advice.
Preparing the surface
Clear the area of furniture and check that windows and doors are securely closed.
Also make sure that plants and trees near the area to be cleaned are protected with a cloth.
Initial high-pressure rinse
Spray the area to be cleaned with water to clean any dirt that may have accumulated on
the surface. Before pressing the trigger, move the spray nozzle to the spray mode position
and progressively move it to the desired spray position. This way, you will avoid applying an
excessively direct jet on more delicate surfaces.
Using soap
Water and soap must be used in a 1:19 ratio: 5.4% soap, 94.6% water.
Warning
Use only soaps designed for pressure washers.
Test the soap in an inconspicuous place before using the product.
Loosen the cap of the soap bottle and ll it with water and soap.
Replace the cover.
Disassemble the lance from the trigger gun.
08139_HydroBoost 2400 AdvanceClean.indd 7008139_HydroBoost 2400 AdvanceClean.indd 70 18/11/22 9:5718/11/22 9:57

Table of Contents

Related product manuals