cecotec Outsider DemiGod Makalu - Operation; Battery Charging

38 39
5. OPERATION
BATTERY CHARGING
NOTE: make sure the device is turned off.
1. Open the charging port’s (1) cover located on the right side of the vehicle and insert the
3-contact power adapter’s end.
2. Connect the other power adapter’s end to a wall power supply. The light indicator will
turn red during charge and will turn green when fully charged.
NOTE:
• The device comes already charged, but it is recommended to charge it for 6-8 hours
before the rst use.
• It is also recommended to charge it after each use and before storing it.
• To avoid the battery from damaging, do not allow the vehicle to fully discharge.
1
3. Assembly
3.1. Headlight assembly
The scooter’s headlights are installed in the position shown below by
default.
In order to install the headlights in the correct position, rst loosen
the screws marked as number 6 and remove them. Then, use 4 M6*16
hexagonal screws and the 4 anged lock nuts to x the headlight bracket
and mount the headlights on it as shown on the picture.
Note: Some of the headlight parts have no use and must be removed.
Please remove the parts shown on the picture below:
3.2. License plate bracket with light assembly
To install the license plate bracket, add a bushing a change both screws.
Change both screw marked as 7 and 8 with 2 M6*30 hexagonal screws.
Then, connect the cable of the license bracket’s light to the cable coming
from the scooter’s board.
3.3. Rear-view mirror assembly
To install the rear-view mirrors, just insert them in the
holes located on the handlebar and screw them tight-
ly. Once they have been screwed, cover the lower part
with the trim.
3.4. Speedometer assembly
To install the speedometer, rst assemble the speedometer bracket
onto the handlebar. To do so, screw 2 M6*10 hexagonal cap head
screws onto the 2 threaded holes on the back of the handlebar as
shown on the picture.
Then, use 2 M4*10 hexagonal cap head screws to x the
speedometer onto the speedometer bracket.
Finally, connect the speedometer cable to the cable on the scooter’s stem.