cecotec SF18650NR-22 - Troubleshooting and Specifications; Troubleshooting; Technical Specifications

SCOBA 2100 TWICE MAX
44
ENGLISH
- You can clean the brushes with warm water, do not use soap or detergents. However, it
is recommended that you shake it out or vacuum it, to avoid inserting it wet in motorised
brush.
- If you decide to wash the brushes, make sure they are completely dry before installing
them again on the vacuum cleaner.
- When replacing the brushes, make sure they are properly installed.
6. TROUBLESHOOTING
Problem Possible cause Possible solution
The vacuum cleaner
does not work.
The battery is exhausted. Charge the battery.
No suction or low suction
power.
The dust tank is full or
clogged.
The dust tank was not
installed correctly.
The lter needs to be
cleaned.
Empty the dust tank and clean
the lter.
Install the dust tank properly.
Clean the lters.
The vacuum cleaner
does not charge.
The power adapter was not
plugged in correctly.
You are not using the
appropriate charger.
Check that the adapter and the
plug are properly connected.
Use only the charger provided
with the vacuum cleaner.
7. TECHNICAL SPECIFICATIONS
Scoba 2100 Twice Max
Product reference: 08413
Motor rated power: 200 W
Charger output: 18 V 0.5 A
Battery data:
14,8 V 2500 mAh 37 Wh
Reference: Scoba 2100 Jalisco Battery Pack
Input: 18 V, 0.5 A
Type: SF18650NR-22
Technical specications may change without prior notication to improve product quality.
Made in China | Designed in Spain