24 | TOTAL IRON 8500 IMPLODE / 9000 TURBO-BOOST
ENGELSK
wound along the cord slot for storage.
Automatic power o
The appliance will turn o automatically after 10 minutes of inactivity.
Dry ironing
Place the iron on the heatproof stand of the unit base.
Connect the plug to a wall outlet, the temperature indicator and the indicator
of MAX. steam rate will turn on.
Turn temperature dial to select the desired temperature setting depending
on the garment’s fabric, the iron will start heating up.
When the selected temperature is reached, the temperature indicator will
turn o. Then, you can start ironing.
Warning: Do not touch the soleplate before it cools down!
Steam ironing
Grasp the water tank’s handle to remove the water tank, then ll it with
water through the lling aperture. Use puried water with few calc particles.
After this, replace the water tank properly. The max capacity of water tank
is 1.8L, the water level should not exceed the MAX mark.
Place the steam station on the thermal insulation stand of the unit base.
Connect the plug to the wall outlet, press the power switch, and the defaulted
low steam rate indicator will ash. There are three modes including low,
medium and high steam rate, you can select the desired steam rate for each
garment according to your requirement. Make sure that there is enough
water in the tank.
Turn the temperature dial to desired setting taking into account the fabric,
and the temperature indicator will illuminate. The steam station will start
emitting heat. Refer to “ironing tips” and “additional table” below when
setting the temperature.
The water in the steam generator will be heated, after a few minutes, then
the temperature indicator will switch o. This indicates that the soleplate
temperature has achieved the selected temperature. When the indicator of
defaulted steam rate changes from ashing to illuminating, it indicates that
the iron is ready for ironing the garment.
Gently press the steam trigger for steam to be sprayed from the soleplate
continuously.
Warning: Never direct the steam at people!
After ironing, press the power switch for about 2 seconds, the appliance
will switch o and with it, all the indicators. Remove the plug from the wall
socket. Be careful, the soleplate will still be hot, never touch it with your
hand. Place it on the heatproof stand until it cools down completely.
To Next Page
Loading...
