Celect CC908-RF - Planning Your Program

To Next Page

To Previous Page

program. See Planning your program section. shows when thermostat is in hold temperature

operation. The thermostat will hold the room temperature at the selected setting.

3) Temperature override

During program operation, Press ▲ or ▼ until the temperature you want is

displayed. shows in temperature override. The thermostat will override the current programming and keep

the room temperature at the selected temperature until the next program period begins. Then the thermostat

will automatically revert to the program.

4) Vacation Temperature hold

Continue pressing button ③ over 3 seconds until display will show indicates you

have now entered into vacation hold， Use time key ② or ③ to select the number of the days (from 1 to

99 days) during your vacation.，you can use ▲ or ▼to adjust the temperature during your holiday. Push

button ④ to revert to program operation.。To the end of vacation time, it will automatically return to the

program is running. In the vacation mode, Push button ④ to revert to program operation.。Vacation

factory set temperature is 10 ℃.

5) Reset operation

If the display is abnormal, press the Reset button by using a fine probe such as a straightened paper

clip to gently push the Rest button. This will reset the thermostat.

3. Set current day and time

1) Press ② button. The display will show the hour flashing.

2) Press and hold either ▲ or ▼ until you reach the correct hour and AM or PM designation.

(AM begins at night, PM begins at noon)

3) Press ② button once again. The display will only show minutes flashing

4) Press and hold either ▲ or ▼ until you reach the correct minutes

5) Press ② button once again. The display will show the day of the week flashing.

6) Press ▲ or ▼ until you reach the correct day of the week

Press button ④ once. The display will show the correct day of the week and the time. If no keys are

pressed within 20 seconds, the thermostat will revert to program operation.

4． Planning your program

Look at the factory preprogrammed times and temperatures shown in the sample schedule. If this

program will suit your needs, simply press the ④ button to begin running the factory preset program.

If you want to change the preprogrammed time and temperature, follow these steps.

Determine the times period and temperature for your program. You must program four periods for

each day. You can choose heating temperature and start time independently. (for example, you may select

5:00 AM and 70℉ as the weekday 1

period heating start time and temperature and also choose 7:00 AM

and 76℉ and the weekday 1

period cooling start time and temperature)

Use the table to plan your program time periods and the temperatures you want during each period. Fill in

the complete table to have a record of your program

Heating Schedule Plan (Factory default program setting)

Wake up Out

door

Back

home

Out

door

Back

home

Sleep