7
Enter Heating Program
1). Press ③ once. 1 (indicating Monday program) will appear in the display. Also be displayed are the
currently programmed start times for the 1st heating period and the currently programmed temperature
(flashing), icon indicates 1
st
program period (Get up) setting。If the display shows 1 2 3 4 5, indicating
that the 5-day program will be modified, you have a 5+1+1 day model. (See configuration menu item 8).
2). Press ▲ or ▼ to change the displayed temperature to your selected temperature for the 1st heating
program period.
3). Press ② once (the programmed time will flash). Press ▲ or ▼ until your selected time appears.
The time will change in 15-minute increments. When your selected time is displayed, press TIME again to
return to the change temperature mode.。
4). Press ③ once, icon 2
nd
program period（Go out）display，the currently programmed start
time and set point temperature for the 2nd heating program period will appear
5). Repeat steps 3 and 4 to select the start time and heating temperature for the 2nd heating program
period.
6). Repeat steps 3 through 5 for the 3rd;4th;5th;6th heating program periods. If 4 period per day selected
in the configuration menu item 9, only 4 period can be programmed each day.
7). Press ③ once. “2” (indicating Tuesday program) will appear in the display, along with the start time
for the 1st heating period and the currently programmed temperature. If the display shows 6, indicating
that Saturday program will be modified in 5+1+1 day model.
8). Repeat steps 3 through 6 to complete Tuesday (7 day model) or Saturday (5+1+1 day model) heating
programming.
9). Continue entering each day’s programming until all heating periods time and temperatures have been
entered.
10). When you have completed entering your heating program, press ④.
7days program refer to above .
REVERT TO FACTORY DEFAULT PROGRAM SETTING
Press ③ button enter into program setting. Press ▲ or ▼ at the same time for 3 seconds. Display will
show DEF blinking for 3 times and back to program setting. Press the ④ button to begin running the
factory preset program. If no keys are pressed within 20 sec, the thermostat will revert to program
operation.
CHECK YOUR PROGRAMMING
Follow these steps to check your thermostat programming one final time before beginning thermostat
operation.
1. Press button ③ to view the 1st weekday heating period time and temperature. Each time you press
button ③, the next heating period time and temperature will be displayed in sequence for weekday,
then Saturday and Sunday program periods (you may change any time or temperature during this
procedure).
Press button ④ to begin program operation.
To Next Page
Loading...