To Next PageTo Next PageWhat to do if my Celli Chiller does not deliver water?
If your Celli Chiller isn't dispensing water, first ensure the main water tap is turned on. Next, check the water supply connection tube for any crushing or obstructions. Finally, verify that the plug is well inserted into the electricity supply.
Why my Celli Brave 30 ES dispenser does not start up?
If your Celli Chiller dispenser isn't starting up, first check that power is present. If the power supply is okay, it may be a thermostat failure, and you should call an authorised technician.
How to fix the issue if Celli Chiller dispensed product is not cold enough?
If the dispensed product from your Celli Chiller isn't cold enough, the ice bank may have run out; wait until it has fully reformed. Also, check that the incoming water temperature is lower than 32°C. If these steps don't resolve the issue, it could be a soda recirculation pump malfunction or inadequate insulation on the python, in which case you should call an authorised technician.
Identifies potential dangers like CO2 leaks, electricity, and refrigerant, plus remaining risks.
Explains the cooling, carbonation, and dispensing mechanisms of the machine.
Covers necessary electrical setup, safety precautions, and water supply hookup.
Procedures for connecting syrup lines, CO2 gas, and soda recirculation.
Step-by-step guide for powering on, ice bank formation, and dispensing drinks.
Lists common machine issues, their probable causes, and recommended remedies.
General