Cellularline Interphone EDGE - Device Status and Initial Setup; Initial Power On Procedures; Language and Audio Settings

ENGLISH - 9 ENGLISH - 10
If you select a wrong language, follow the steps below:
1. Turn o the EDGE. (Press the MFB for 5s, or unl the led lights RED).
2. Turn on the EDGE (Press the MFB for 2s).
3. Short press UP buon (2).
4. Short press MFB buon (1).
5. Short press UP buon (2).
6. Press MFB when you hear your language.
2.6 Audio priories
EDGE determinates the audio source priority in the following way:
1. Mobile phone
2. Intercom
3. A2DP audio (Smartphone/Player MP3)
4. FM Radio
Example:
● Incoming mobile call interrupt ongoing A2DP music.
● Incoming Intercom call does not interrupt an ongoing mobile phone call; the rider,
who started the intercom call, will hear a “connection failed” message.
2.2 Status led (Pic.2)
Standby BLUE led (6) ashes every 3 seconds.
Intercom acve BLUE led (6) is solid.
Interphone connected with
mobile/GPS
BLUE led (6) ashes twice every 3 seconds.
Pairing mode BLUE (6) and RED (6) led ash alternately.
Charging
ORANGE led (6) is solid. When charging is completed
led (6) becomes solid GREEN.
Baery low Led (6) is solid RED.
2.3 First Switch on (only twin pack)
Press MFB (1) buon to turn on both units. The units are already factory-
paired, wait for your language and press MFB (1) buon to conrm.
Later two units will be in “INTERCOM” Standby status (Chapter 4).
2.4 First Switch on (only single pack)
Press MFB (1) buon to turn on unit.
The unit will enter in “PAIRING MODE”, choose one of these:
- Pairing with mobile phone or GPS navigator.
- Short press of Up (2) buon – intercom pairing with INTERPHONE device.
- Short press of DOWN (3) buon – intercom pairing with other brand device(NON
INTERPHONE) ANYCOM mode.
- Long press of MFB (1) unl the beep – to cancel “PAIRING MODE”. Unit will enter in
“INTERCOM” Standby status(Chapter 4) and Blue led (6) will ash every 3 seconds.
2.5 Language selecon (aer rst switch on):
EDGE in Standby mode (Blue led(6) ashing), press UP buon(2) and then MFB buon(1)
to enter in “SETUP” menu. Press again UP buon(2), “LANGUAGE SELECTION” start,
wait for your language and then press MFB buon (1)to conrm it.