WALL-MOUNTED ELECTRIC FIREPLACE/HEATER
BFM EUROPE LTD Page 8
INSTALLATION INSTRUCTIONS
Step 7: Fit the appliance front fascia by locating the two tabs into the slots on top of the electric fire as
shown below . (Figure 6)
Secure the fascia in place at both sides using the two supplied screws.
Figure 6
NOTE: Removal of the electric fire is carried out by following the previous steps in reverse order.
CAUTION! THE UNIT’S POWER CORD MUST BE CONNECTED TO A PROPERLY
EARTHED AND PROTECTED 230V OUTLET. ALWAYS USE EARTH FAULT PROTECTION
WHERE REQUIRED BY THE ELECTRICAL CODE.
This appliance can be operated by both a remote control and a manual keypad. Once the unit has been
properly connected to an earthed electrical socket-outlet ensure the manual On/Off switch, located on
the right hand side of the appliance, is in the ‘ON’ position.
MAUNAL ON/OFF SWITCH
This switch turns the appliance on/off. The manual on/off switch must be in the ‘ON’ position when
using both remote and manual operation.
WARNING! DO NOT OPERATE THE UNIT IF IT IS DAMAGED OR HAS MALFUNCTIONED. IF
YOU SUSPECT THE UNIT IS DAMAGED PLEASE CALL A QUALIFIED SERVICE TECHNICIAN TO
INSPECT AND TO REPLACE ANY PART OF THE ELECTRICAL SYSTEM IF NECESSARY.
To Next Page
Loading...