Cembre B35 - General Characteristics

ENGLISH
BATTERY OPERATED HYDRAULIC CUTTING TOOL
B35-TFC ; B35-TFCA
1. GENERAL CHARACTERISTICS
3 32
B35-TFCA
suitable for cutting grooved contact wires and
conductors used on electric traction systems.
450 (6,500)
370 x 187 x 86 (14.6 x 7.4 x 3.4)
3,4 (7.5)
9.6
9.6 / 2.0 Ni-MH
AGIP ARNICA 22 or ESSO INVAROL EP22 or equivalent.
the tool is equipped with a maximum pressure valve.
-15°C to +40°C (+5°F to +104°F)
Application range:
Rated operating pressure bar (psi):
Dimensions
LxWxH mm (inches):
Weight with battery kg (lbs):
Motor Volt DC:
Battery
type CB9620H Volt / Ah:
Battery charger supply Volt / Hz:
Recommended oil:
Safety:
Operating temperature:
Acoustic Noise (Directive 2006/42/EC, annexe 1, point 1.7.4.2 letter u)
– The weighted continuous acoustic pressure level equivalent
A at the work place L
pA
is equal to ............................................................................. 66,8 dB (A)
– The maximum value of the weighted acoustic displacement
pressure C at the work place L
pCPeak
is .....................................................................< 130 dB (C)
– The acoustic power level emitted by the machine
L
WA
is equal to ...............................................................................................................75 dB (A)
Risks due to vibration (Directive 2006/42/EC, annexe 1, point 2.2.1.1)
Tests carried out in compliance with the indications contained in UNI ENV 25349 and UNI EN 28662
part 1
st
Standards, and under operating conditions much more severe than those normally found,
certify that the weighted root mean square in frequency of the acceleration the upper limbs
are exposed to for each biodynamic reference axis does not exceed 2.5 m/sec
2
.
TOOL TYPE:
B35-TFC
220 - 240 / 50 - 60 120 / 50 - 60
The tool can be held in one hand while positioning the conductor with the other.
Residual battery energy level is automatically displayed after every cycle.
The part references “B35-TFC ; B35-TFCA” include the following:
– Basic tool complete with battery.
– Spare battery.
– Battery charger complete with CBA96-144 adapter.
– Plastic carrying case VAL P32.
*
24
26
31
27
19
18
72
17
75
4
19
18
1
250
10
9
30
8
210
20
16
17
15
11
8
9
6
7
67
16
350
67
64
65
66
310
70
45
63
77
21
57
360
71
62
300
15
100
11
220
500
400
69
68
78
85
84
TIGHTENING TORQUE COUPLE DE SERRAGE DREHMOMENT PAR DE TORSION COPPIA DI SERRAGGIO
.MLBFFT
D
TABLE 2 - TABLEAU 2 - TABELLE 2 -
TABLA 2 - TAVOLA 2
See TABLE 3 - Voir TABLEAU 3
siehe TABELLE 3 - Ver TABLA 3
Vedere TAVOLA 3